Wheels again today (and so on...).
I built Nomu Lab Wheel #1.
The front wheel uses a Tni Evo front hub 20H from our shop stock,
built with CX-RAY inpoke radial lacing.
The rear wheel is 28H, but
I swapped in a DT350 hub and built it as a semi-comp 48-spoke pattern.
That "true 48-spoke build!" radial characteristic really shows up more on the non-high-low flange side,
and sure enough, that's how it turned out again.
I'm almost thinking the non-freewheel side lacing might be unnecessary.
(There's no lacing in the image yet, we just haven't gotten to it)
Here at the shop, we're building wheels every day right now,
but every single wheel is different, even when they look similar.
Of course we're not reusing the same photos.
Once in a while I snap a shot like this ↑ (laugh).
I built Nomu Lab Wheel #1.
The front wheel uses a Tni Evo front hub 20H from our shop stock,
built with CX-RAY inpoke radial lacing.
The rear wheel is 28H, but
I swapped in a DT350 hub and built it as a semi-comp 48-spoke pattern.
That "true 48-spoke build!" radial characteristic really shows up more on the non-high-low flange side,
and sure enough, that's how it turned out again.
I'm almost thinking the non-freewheel side lacing might be unnecessary.
(There's no lacing in the image yet, we just haven't gotten to it)
Here at the shop, we're building wheels every day right now,
but every single wheel is different, even when they look similar.
Of course we're not reusing the same photos.
Once in a while I snap a shot like this ↑ (laugh).