A customer brought in their Nomu Lab Wheel #1 (custom wheel) with a PowerTap hub for service.
They wanted the hub overhauled, so I also did some wheel truing while I had it.
The reason I'm standing here is because there's a sticker the customer put on the rim.
This image is after the work (the sprocket and rim have been cleaned).
Since this is a pretty early Nomu Lab wheel
The rim tape wasn't cut properly, so I took care of that too.
The U-shaped groove in the water seal is supposed to face the freebody side,
so this isn't the direction it gets installed, but
I figured I might as well clean it thoroughly.
I cleaned the hub internals too.
The bearings weren't damaged, so after cleaning I just re-greased them.
I cleaned the sprocket too.
They wanted the hub overhauled, so I also did some wheel truing while I had it.
The reason I'm standing here is because there's a sticker the customer put on the rim.
This image is after the work (the sprocket and rim have been cleaned).
Since this is a pretty early Nomu Lab wheel
The rim tape wasn't cut properly, so I took care of that too.
The U-shaped groove in the water seal is supposed to face the freebody side,
so this isn't the direction it gets installed, but
I figured I might as well clean it thoroughly.
I cleaned the hub internals too.
The bearings weren't damaged, so after cleaning I just re-greased them.
I cleaned the sprocket too.