Another day of wheel building (and so on).
Built the rear wheel for Nomu Lab Wheel No. 5 using a 7400 rear hub.
Since it's not a freewheel hub, it's not an FH model number
but rather HB-7400 (rear hub) 32H, laced in half-competition four-cross pattern.
I'll do the cable routing later.
This is a threaded cup-and-cone hub, and the
locknut-to-locknut dimension is nominally 126mm, measuring 126.5mm in reality.
Modern 142mm-width through-axle rear hubs,
structurally speaking, have several theoretical disadvantages
compared to this threaded hub.
With those massive low gears and disc rotors,
the evolution has been rather lopsided, hasn't it?
Built the rear wheel for Nomu Lab Wheel No. 5 using a 7400 rear hub.
Since it's not a freewheel hub, it's not an FH model number
but rather HB-7400 (rear hub) 32H, laced in half-competition four-cross pattern.
I'll do the cable routing later.
This is a threaded cup-and-cone hub, and the
locknut-to-locknut dimension is nominally 126mm, measuring 126.5mm in reality.
Modern 142mm-width through-axle rear hubs,
structurally speaking, have several theoretical disadvantages
compared to this threaded hub.
With those massive low gears and disc rotors,
the evolution has been rather lopsided, hasn't it?