Another wheel build day (and so on).
Built the front wheel with an RR411 rim, hoping no one realizes it's my personal bike.
This rim has stickers labeled "RR411" at two locations roughly 180° apart,
but on the opposite side they're positioned 90° offset.
The side where the sticker is directly below the valve is my designated right side,
and my rule is to remove all stickers except the one directly across from the right valve hole.
↑This is how I do it with the XR331 rim on the rear wheel
DT240s straight-pull spoke hub, 20H
built fully with CX Sprint in forced radial pattern
Rainbow-sequence (VAS pattern) aluminum nipples.
Built the front wheel with an RR411 rim, hoping no one realizes it's my personal bike.
This rim has stickers labeled "RR411" at two locations roughly 180° apart,
but on the opposite side they're positioned 90° offset.
The side where the sticker is directly below the valve is my designated right side,
and my rule is to remove all stickers except the one directly across from the right valve hole.
↑This is how I do it with the XR331 rim on the rear wheel
DT240s straight-pull spoke hub, 20H
built fully with CX Sprint in forced radial pattern
Rainbow-sequence (VAS pattern) aluminum nipples.