Continuing from last time.
I built a rear wheel with an XR331 rim.
FH-RS770 28H, black half-comp, 4-cross JIS lacing with spoke twist, though a 6-cross pattern might have worked too.
Since this is a rear wheel for a Cannondale AI (Asymmetric Integration) frame, I needed to offset the center, and there's almost no dish adjustment possible. The offset amount is 6mm, but the correct measurement is 12mm for the gap when you take a measurement from the right dropout and apply it to the left dropout. I mentioned previously that I offset it 6mm when building an AI rear wheel before (→here), but that was a calculation error that I corrected later.
I also installed a tire so I can check whether the sealant is working properly.
I built a rear wheel with an XR331 rim.
FH-RS770 28H, black half-comp, 4-cross JIS lacing with spoke twist, though a 6-cross pattern might have worked too.
Since this is a rear wheel for a Cannondale AI (Asymmetric Integration) frame, I needed to offset the center, and there's almost no dish adjustment possible. The offset amount is 6mm, but the correct measurement is 12mm for the gap when you take a measurement from the right dropout and apply it to the left dropout. I mentioned previously that I offset it 6mm when building an AI rear wheel before (→here), but that was a calculation error that I corrected later.
I also installed a tire so I can check whether the sealant is working properly.