A customer brought in their Nomu Lab Wheel No. 5 for work.
Starting with the rear wheel.
They wanted to rebuild it with an AL22W rim,
and since the rim inner diameters are very similar, I could reuse the spokes.
Moving the rim over...
Both before and after the rebuild have red aluminum nipples,
but I replaced those with new ones instead of reusing them.
Built it up.
Wait, not yet.
While I was rebuilding, I also needed to
swap in an XDR freebody,
but I forgot and finished building the wheel.
Built it up.
Swapping from a Shimano 11S freebody to an XDR freebody
shouldn't shift the wheel center,
but the rim shifted left by about the thickness of a sheet of paper.
It might have changed depending on how tight I cinched the axle nuts
when replacing the freebody.
The image above is after I corrected that.
Next, the front wheel.
Moving the rim over...
Built it up.
Starting with the rear wheel.
They wanted to rebuild it with an AL22W rim,
and since the rim inner diameters are very similar, I could reuse the spokes.
Moving the rim over...
Both before and after the rebuild have red aluminum nipples,
but I replaced those with new ones instead of reusing them.
Built it up.
Wait, not yet.
While I was rebuilding, I also needed to
swap in an XDR freebody,
but I forgot and finished building the wheel.
Built it up.
Swapping from a Shimano 11S freebody to an XDR freebody
shouldn't shift the wheel center,
but the rim shifted left by about the thickness of a sheet of paper.
It might have changed depending on how tight I cinched the axle nuts
when replacing the freebody.
The image above is after I corrected that.
Next, the front wheel.
Moving the rim over...
Built it up.